How to treat heat-printer

Printer is a tool that is very important unit of your computer. The printer is usually used as printing the desired image to a paper. In general, the printer has a variety of types / type of use of ink, ribbon, toner, and others.
Because the printer is an important tool that we as owners need to be cleaned regularly. In general, most people prefer because of the printer ink costs more practical and not too expensive. Type of printer ink will be practical even though treatment is not easy but if you want your printer is durable. This type of printer to be used as material tintanya easy to dry, or choke on its Head. In general, the printer ink divided into 2 types, namely:
1.Tangki ink that becomes one with his Nose Head (Canon, Hp)
2. The separate ink tanks with his Nose Head (Epson)
To this article, I will discuss printer ink type 1 is a tank tintanya become one with its Head. In general, improvements to one type printer ink is very expensive. Because if its Head, we stopped to purchase a new Head of the price almost the same as the price of the printer itself. Therefore I will give some tips so that your printer is not easily damaged.



For treatment we need some material that is liquid solvents, Head printer, mineral glass, tissue paper, and the needle tool through rubber pipes. Ropes can be seen as follows:
Head 1.Lepas on your printer.
2.Potong mineral glass at 3 cm from the base.
3.Tuangkan Head cleaning fluid on the mineral glass at 5 mm from the base glass.
Head 4.Rendam edge in liquid for 10 ± s / d 15-minute maximum of 2 hours.
5.Letakkan the end of the injection is through the rubber pipe from the air hole and then hisap Head in the air so that little fluid diujung Head terhisap Head into the tank, and then press the air into the tank so that the tip of the ink head is visible in the fluid from the air bubbles in the ink, including the remaining ink in the tank.
6.Setelah many bubbles are out, then the sign is lubangnya Head has returned.
Head 7.Bersihkan edge with tissue paper to dry, including the terminal elektriknya.
Head 8.Letakkan end of the tissue paper on the net. Wind instrument air back into the tank so that the visible ink ink out of the end of the Head and imprint on the tissue.
Head 9.Kemudian crown back on the printer, tried to print the Ready, if not better when cetakannya repeat step 4 until 9 to cetakannya good results.
10.Bila already do not get 5 times the mold has not been good this means that your head has been damaged / can not be repaired again.

Well now you already know how to treat Head on your printer. So if on a printer when you have a problem you do not live under ketempat services but try your own countdown betulkan count to save costs. The article of me